Skip to content

Access control and door entry in Telford

The right people, through the right doors. Door entry and managed access for offices, apartment buildings and commercial premises.

Sheet
Access control & door entry
Base
Telford, Shropshire
Coverage
Shropshire & West Midlands
Engineer checking a commercial access control reader

What we do

We assess the site, select the right control approach and commission each point of entry for straightforward daily use.

  • 01Standalone and networked systems
  • 02Readers, controllers and exit devices
  • 03Credential setup and handover
  • 04Door release and power supply fault finding
  • 05Hardware alignment and reader checks
  • 06Support for ASSA ABLOY SMARTair and Aperio solutions
WhatsApp us

Our approach

Access control that suits the people using the doors every day

Equipment we install and support

  • Paxton
  • ASSA ABLOY
  • SMARTair

Access control should make a building easier to run. Staff get in without keys, visitors are let in by the right person and you can remove a lost fob in seconds instead of changing locks. We design systems around who needs to go where, and when.

For a single entrance a standalone keypad or fob reader is often enough. Offices, shared buildings and sites with several doors usually benefit from a networked system, where users, schedules and door events are managed from one place and access can be changed without visiting the door.

We install readers, controllers, locking hardware, exit buttons, door entry panels and power supplies, and set up credentials and user groups at handover. Where battery-powered wireless locks make more sense than running cables to every door, we support ASSA ABLOY SMARTair and Aperio solutions.

On escape routes, door release has to work with the fire alarm. We plan how each door fails, so a power loss or fire signal releases the doors that must open, while the doors that need to stay secure remain locked.

What to expect

How a job runs, from survey to handover

  1. Stage 01

    Door survey

    We check each door, its frame and hardware, the cable routes and whether it forms part of an escape route.

  2. Stage 02

    System design

    You get a written quote covering readers, locks, controllers and how users and schedules will be managed.

  3. Stage 03

    Installation and commissioning

    Hardware is fitted and aligned, and each door is tested for locking, release and fire alarm interface.

  4. Stage 04

    Credentials and handover

    We enrol users, set access groups and show you how to add or remove people yourself.

Standards and guidance

What applies to this work

General guidance only. The requirements for a specific property depend on its use, its risk assessment and any insurer or contract terms.

BS EN 60839-11-1

European standard for the functional performance of electronic access control systems.

BS 7273-4

Covers how fire alarm signals release doors fitted with electrically powered locks on escape routes.

Approved Document B

Building Regulations guidance on means of escape, which affects how secured doors must behave in an emergency.

Questions answered

Common questions about access control and door entry

Fobs, cards, PIN codes or phones?

Fobs and cards are simple and cheap to replace. PIN codes avoid carrying anything but are easy to share. Many systems now support mobile credentials too. We often combine methods depending on the door and the users.

What happens to the doors in a power cut?

That depends on the lock type and how it is wired. Escape doors are usually set to release on power loss, while doors protecting stock or equipment can be set to stay locked. We decide this door by door with you.

Can access control link to the fire alarm?

Yes, and on escape routes it normally must. A fire alarm signal releases the designated doors so people can get out. We test this interface during commissioning.

Can you add access control to an existing door entry system?

Often, yes. We check the existing equipment first and tell you whether it can be extended or whether a replacement will be more reliable.

Do you install door entry for flats and apartment buildings?

Yes. We install and maintain audio and video door entry panels for apartment blocks, with fob access for residents where required.

Professional access control and door entry across Telford, Shropshire and the West Midlands.

  • Telford
  • Shrewsbury
  • Wolverhampton
  • Stafford
  • Shropshire
  • West Midlands

Customer reviews

Rated by the people we protect.

5.06 Google Reviews
Outstanding experience! The installers were professional, friendly, and highly skilled. They did a perfect job setting up my security cameras and explained how to use everything clearly. The whole process was smooth and stress-free. I feel much more secure now thanks to their excellent work. Highly recommended!
Bogdan CiorneiCCTV Installation · Google review
“Recently employed VMT Solutions to advise and install Intruder detection system and video surveillance system at my property. Excellent advice on type of equipment and locations, and this was followed by a first rate installation. Would highly recommend VMT Solutions.”
Steve BrownIntruder Alarms & CCTV · Google review
“Had CCTV and an intruder alarm fitted at home by VMT Solutions Ltd. They gave clear advice on what equipment would suit the house and didn’t try to push anything unnecessary. The installation was tidy, the cables were hidden well, and they explained how to use the system afterwards. I can now check the house while I’m away for work or on holiday. Would recommend.”
Trofin Adrian CostantinCCTV & Intruder Alarm · Google review

Start a quote

Tell us about the property and we'll recommend a practical next step.

01952 947 963
Call WhatsApp